Project Gallery
Archive for October 2014
-
Q a four wheeled trainer
Submitted by: jinxQ designed using sketchup and printed on my prusa i2 Q uses the 28x2 shield for motor control and a 14m2 for servo control shield been modded to use the ERF...
View Project
Past Competition WinnersView all winners
-
Four Stage Personal Cooling Fan
Submitted by: seldomNeeded a personal cooling fan so decided to build this just for fun, Used a Picaxe 20M2.Increases speed with each stage and then decreases with each stage. ...
View Project -
timed thermostat
Submitted by: newplumberIn USA off peak hours are cheaper then peak hours for electricity so for a friend I built a thermostat that keeps his shed a few degrees above freezing like...
View Project -
Car Parking Assistant
Submitted by: Derby_DonUsing the PicAxe 08M2 this project will make sure that your car is always parked at the exact spot in your garage. This is a neat little addition to any gara...
View Project